ZyXEL Communications P-662HW-D - Figure 297 Displaying Log Categories Example; Figure 298 Displaying Log Parameters Example

Appendix J Command Interpreter
P-662H/HW-D Series User’s Guide
438
Command Examples
This section provides some examples of commands you can use on the ZyXEL Device. This
list is intended as a general reference of examples. The commands available in your ZyXEL
Device may differ from the examples given here. See the other appendices for more examples.
Configuring What You Want the ZyXEL Device to Log
1 Use the sys logs load command to load the log setting buffer that allows you to
configure which logs the ZyXEL Device is to record.
2 Use
sys logs category to view a list of the log categories.
Figure 297 Displaying Log Categories Example
3 Use sys logs category followed by a log category to display the parameters that
are available for the category.
Figure 298 Displaying Log Parameters Example
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that category.
Not every parameter is available with every category.
5 Use the
sys logs save command to store the settings in the ZyXEL Device (you must
do this in order to record logs).
Displaying Logs
• Use the sys logs display command to show all of the logs in the ZyXEL Device’s
log.
• Use the
sys logs category display command to show the log settings for all of the
log categories.
ras> sys logs category
8021x access attack display
error icmp ike ipsec
javablocked mten packetfilter ppp
cdr pki tls remote
tcpreset traffic upnp urlblocked
urlforward wireless
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/1:show debug
type]