Chapter 5 WAN Setup
P-662H/HW-D Series User’s Guide
86
5.5 Internet Connection
Use this screen to change your ZyXEL Device’s WAN remote node settings. Click Network >
WAN to view the screen as shown. The screen differs by the encapsulation.
See Section 5.1 on page 81 for more information.
Figure 43 Internet Connection (PPPoE)
The following table describes the labels in this screen.
Table 21 Internet Connection
LABEL DESCRIPTION
General
Name Enter the name of your Internet Service Provider, e.g., MyISP. This information
is for identification purposes only.
Mode Select Routing (default) from the drop-down list box if your ISP allows multiple
computers to share an Internet account. Otherwise select Bridge.
Encapsulation Select the method of encapsulation used by your ISP from the drop-down list
box. Choices vary depending on the mode you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET
ENCAP or PPPoE.
User Name (PPPoA and PPPoE only) Enter the user name exactly as your ISP assigned. If
assigned a name in the form user@domain where domain identifies a service
name, then enter both components exactly as given.
To Next Page
Loading...
