Chapter 7 Wireless LAN
P-870HN-5xb User’s Guide
130
Click Network > Wireless LAN >WPS. The following screen displays.
Figure 61 Network > Wireless LAN > WPS
The following table describes the labels in this screen.
7.7 The WPS Station Screen
Use this screen to set up a WPS wireless network using either Push Button
Configuration (PBC) or PIN Configuration.
Table 34 Network > Wireless LAN > WPS
LABEL DESCRIPTION
WPS Setup
Enable WPS Select the check box to activate WPS on the Device.
PIN Number This shows the PIN (Personal Identification Number) of the Device. Enter
this PIN in the configuration utility of the device you want to connect to
using WPS.
The PIN is not necessary when you use WPS push-button method.
Generate Click this button to have the Device create a new PIN.
WPS Status This displays Configured when the Device has connected to a wireless
network using WPS or Enable WPS is selected and wireless or wireless
security settings have been changed. The current wireless and wireless
security settings also appear in the screen.
This displays Unconfigured if WPS is disabled and there is no wireless
or wireless security changes on the Device.
Apply Click Apply to save your changes back to the Device.
To Next Page
Loading...
