ZyXEL Communications P-870HN-5xb - Activate WPS; The WPS WLAN Button; Turn the Wireless LAN off or on; Using the Reset Button

Chapter 1 Introducing the Device
P-870HN-5xb User’s Guide
26
1.6.1 Using the Reset Button
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.
1.7 The WPS WLAN Button
You can use the WPS WLAN button at the rear panel of the device to turn the
wireless LAN off or on. You can also use it to activate WPS in order to quickly set
up a wireless network with strong security.
1.7.1 Turn the Wireless LAN Off or On
1 Make sure the POWER LED is on (not blinking).
2 Press the WPS WLAN button for one second and release it. The WLAN/WPS LED
should change from on to off or vice versa.
1.7.2 Activate WPS
1 Make sure the POWER LED is on (not blinking).
2 Press the WPS WLAN button for more than five seconds and release it. Press the
WPS button on another WPS -enabled device within range of the Device. The
WLAN/WPS LED should flash while the Device sets up a WPS connection with the
wireless device.
Note: You must activate WPS in the Device and in another wireless device within two
minutes of each other. See Section 7.10.4 on page 139 for more information.