Chapter 5 WAN Setup
P-870HN-5xb User’s Guide
91
5.6.1.5 Default Gateway
The screen is not available when you select Bridging in the WAN Service
Configuration screen.
Figure 41 WAN Configuration: Default Gateway: PPPoE, PPPoA, IPoE or IPoA
The following table describes the labels in this screen.
Enable MLD
Multicast Proxy
Select Enable to have the ZyXEL Device act as an MLD proxy on this
connection. This allows the ZyXEL Device to get subscription
information and maintain a joined member list for each multicast
group. It can reduce multicast traffic significantly.
Back Click this button to return to the previous screen.
Next Click this button to continue.
Table 19 WAN Configuration: NAT, IGMP Multicast and Firewall Activation: IPoE
LABEL DESCRIPTION
Table 20 WAN Configuration: Default Gateway: PPPoE or IPoE
LABEL DESCRIPTION
Selected Default
Gateway
Interfaces
Select a WAN interface through which you want to forward the traffic.
You can select multiple WAN interfaces for the device to try. The
Device tries the WAN interfaces in the order listed and uses only the
default gateway of the first WAN interface that connects; there is no
backup WAN function. To change the priority order remove them all
and add them back in again.
Available Routed
WAN Interfaces
These are the WAN interfaces you can select from.
Selected WAN
Interface
Select a WAN interface through which to forward IPv6 traffic.
Back Click this button to return to the previous screen.
Next Click this button to continue.
To Next Page
Loading...
