Chapter 16 Quality of Service (QoS)
P-870HN-5xb User’s Guide
199
16.4.1 Adding a QoS Queue
Click the Add button or the edit icon in the Queue Setup screen to configure a
queue.
Figure 103 QoS Queue Setup: Add
The following table describes the labels in this screen.
Table 69 QoS Queue Setup: Add
LABEL DESCRIPTION
Enable Select this to have the Device’s QoS use this queue.
Name Enter the descriptive name of this queue.
Outgoing
Interface
Select the WAN interface to which this queue is applied.
Priority Select the priority level (from 1 to 3) of this queue.
The smaller the number, the higher the priority level. Traffic assigned to
higher priority queues gets through faster while traffic in lower priority
queues is dropped if the network is congested.
Weight Select the weight (from 1 to 8) of this queue.
If two queues have the same priority level, the Device divides the
bandwidth across the queues according to their weights. Queues with
larger weights get more bandwidth than queues with smaller weights.
Buffer
Management
This field displays Drop Tail (DT) and the Device drops the newly arriving
packet when the queue is full.
Rate Limit Specify the maximum transmission rate (in Kbps) allowed for traffic on
this queue.
Back Click Back to return to the previous screen without saving.
To Next Page
Loading...
