ZyXEL Communications P-870HN-5xb - Navigation Panel

Chapter 3 Introducing the Web Configurator
P-870HN-5xb User’s Guide
54
3.2.1 Navigation Panel
Use the menu items on the navigation panel to open screens to configure Device
features. The following tables describe each menu item.
Table 3 Navigation Panel Summary
LINK TAB FUNCTION
Status This screen shows the Device’s general device and network status
information. Use this screen to access the statistics and client list.
Network
WAN Mode Use this screen to set whether or not the Device uses PTM over
ADSL.
Layer 2
Interface
Use this screen to add or remove a DSL PTM (Packet Transfer
Mode) interface.
Internet
Connection
Use this screen to configure ISP parameters, WAN IP address
assignment, and other advanced properties.
LAN IP Use this screen to configure LAN TCP/IP, DHCP and IP alias
settings.
DHCP Client
List
Use this screen to look at the IP addresses currently assigned to
DHCP clients and the IP addresses reserved for specific MAC
addresses.
IPv6 Use this screen to specify LAN IPv6 settings.
Wireless LAN General Use this screen to configure the wireless LAN settings, WLAN
authentication/security settings and MAC filtering rules.
More AP Use this screen to configure multiple BSSs on the Device.
WPS Use this screen to enable WPS (Wi-Fi Protected Setup) and view
the WPS status.
WPS Station Use this screen to use WPS to set up your wireless network.
WDS Use this screen to set up Wireless Distribution System links to
other access points.
Advanced
Setup
Use this screen to configure the advanced wireless LAN settings.
NAT Port
Forwarding
The NAT screens are available only when you enable NAT in a
WAN connection.
Use this screen to make your local servers visible to the outside
world.
Trigger Port Use this screen to change your Device’s port triggering settings.
DMZ Host Use this screen to configure a default server which receives
packets from ports that are not specified in the Port Forwarding
screen.
ALG Use this screen to allow SIP sessions to pass through the Device.
Security
MAC Filter Use this screen to configure filtering rule(s) that blocks or allows
traffic according to its destination and/or source MAC address in
bridge mode.