Chapter 5 WAN Setup
P-870HN-5xb User’s Guide
82
The following table describes the labels in this screen.
5.6.1.2 Service Type
If you set the DSL link type to PPPoA or IPoA for the ATM interface and configure
a WAN connection using the ATM interface, you only need to configure the Enter
Service Description field in this screen.
Figure 35 WAN Configuration: Service Type
Figure 36 The following table describes the labels in this screen.
Table 14 WAN Configuration: WAN Interface
LABEL DESCRIPTION
Select a layer 2
interface for this
service
Select ptm0 to use the DSL port as the WAN port and use the VDSL
technology for data transmission.
Select atm0 to use the DSL port as the WAN port and use the ADSL
technology for data transmission.
Back Click this button to return to the previous screen.
Next Click this button to continue.
Table 15 WAN Configuration: Service Type
LABEL DESCRIPTION
Select WAN
service type
Select the method of encapsulation used by your ISP.
Choices are PPP over Ethernet (PPPoE), IP over Ethernet and
Bridging.
Enter Service
Description
Specify a name for this connection or use the automatically generated
one.
To Next Page
Loading...
