Chapter 18 Remote Management
P-870HN-5xb User’s Guide
223
18.3 The TR-064 Screen
TR-064 is a LAN-Side DSL CPE Configuration protocol defined by the DSL Forum.
TR-064 is built on top of UPnP. It allows the users to use a TR-064 compliant CPE
management application on the their computers from the LAN to discover the CPE
and configure user-specific parameters, such as the username and password.
Click Advanced > Remote MGMT > TR064 to open the following screen.
Figure 111 TR-064
The following table describes the fields in this screen.
Connection
Request
Password
Enter the connection request password.
When the ACS makes a connection request to the Device, this
password is used to authenticate the ACS.
Connection
Request URL
This shows the connection request URL.
The ACS can use this URL to make a connection request to the Device.
Apply/Save Click this button to save your changes back to the Device.
Cancel Click Cancel to begin configuring this screen afresh.
Table 78 TR-069 (continued)
LABEL DESCRIPTION
Table 79 TR-064
LABEL DESCRIPTION
Enable TR064 Select the check box to activate management via TR-064 on the LAN.
Apply Click this button to save your changes back to the Device.
To Next Page
Loading...
