ZyXEL Communications P-870HN-5xb - Page 222

Chapter 18 Remote Management
P-870HN-5xb User’s Guide
222
Click Advanced > Remote MGMT to open the following screen. Use this screen
to configure your P-870HN to be managed by an ACS.
Figure 110 TR-069
The following table describes the fields in this screen.
Table 78 TR-069
LABEL DESCRIPTION
Inform Select Enable to activate remote management via TR-069 on the
WAN. Otherwise, select Disable.
Inform Interval Enter the time interval (in seconds) at which the Device sends
information to the auto-configuration server.
ACS URL Enter the URL or IP address of the auto-configuration server.
ACS User Name Enter the TR-069 user name for authentication with the auto-
configuration server.
ACS Password Enter the TR-069 password for authentication with the auto-
configuration server.
WAN Interface
used by TR-069
client
Select a WAN interface through which the TR-069 traffic passes.
Display SOAP
messages on
serial console
Select Enable to show the SOAP messages on the console.
Connection
Request
Authentication
Select this option to enable authentication when there is a connection
request from the ACS.
Connection
Request User
Name
Enter the connection request user name.
When the ACS makes a connection request to the Device, this user
name is used to authenticate the ACS.