ZyXEL Communications P-870HN-5xb - Page 261

Chapter 24 Logs
P-870HN-5xb User’s Guide
261
To change your Device’s log settings, click Maintenance > Logs > Log Settings.
The screen appears as shown.
Figure 142 Maintenance > Logs > Log Settings
The following table describes the fields in this screen.
Table 95 Maintenance > Logs > Log Settings
LABEL DESCRIPTION
Enable Select this to turn on system logging.
Log Level Select the severity level of the logs that you want the Device to display,
record and send to the log server.
The Device displays and records the logs with the severity level equal to
or higher than what you selected.
Mode Select Local to record the logs and store them in the local memory of the
Device only.
Select Remote to send logs to the specified log server.
Select Both to record the logs and store them in the local memory and
also send logs to the log server.
Syslog Server
IP Address
Enter the server name or the IP address of the log server.
Syslog Server
UDP Port
Enter the UDP port of the log server.
Apply Click Apply to save your customized settings.