Chapter 7 Wireless
VMG1312-B Series User’s Guide
119
Note: The Device applies the securit y set t ings of the SSI D1 profile ( see
Section 7.2 on
page 108) . I f you want to use the WPS feat ure, m ake sure you have set the
security m ode of SSI D 1 to W PA- PSK, W PA2 - PSK or No Se cur ity.
Click Ne t w ork Se t t ing > W ir eless > W PS. The following screen displays. Select Ena ble and click
Apply to act ivate t he WPS funct ion. Then you can configure t he WPS sett ings in this screen.
Figure 37 Net work Sett ing > Wireless > WPS
The following t able describes t he labels in t his screen.
Table 23 Network Sett ing > Wireless > WPS
LABEL DESCRIPTION
WPS Select En a ble to activate WPS on the Device.
Method 1 Use t his section t o set up a WPS wireless network using Push Button Configuration ( PBC).
Connect Click t his but ton to add anot her WPS- enabled wireless device (within wireless range of t he
Device) to your wireless net work . This butt on m ay eit her be a physical but t on on the
out side of device, or a m enu button sim ilar to the Connect button on this screen.
Note: You must press the other wireless device’s WPS button within two minutes of pressing
this button.
Method 2 Use this sect ion t o set up a WPS wir eless network by enter ing the PI N of t he client into the
Device.
Register Enter t he PI N of the device that you are sett ing up a WPS connection wit h and click
Regist er t o aut hent icat e and add t he wireless device t o your wireless network.
You can find the PI N either on t he outside of t he device, or by checking the dev ice’s
settings.
Note: You must also activate WPS on that device within two minutes to have it present its PIN
to the Device.
Method 3 Use this sect ion t o set up a WPS wireless network by entering t he PI N of the Device into t he
client.
To Next Page
Loading...
