Chapter 1 Introducing the Device
VMG1312-B Series User’s Guide
21
1.6 The RESET Button
I f you forget your password or cannot access the web configurat or, you will need t o use t he RESET
butt on at the back of t he device t o reload t he factory- default configuration file. This m eans t hat you
will lose all configurat ions that you had previously and the password w ill be reset to “ 1234”.
1 Make sure the POW ER LED is on ( not blinking).
2 To set t he device back to the fact ory default sett ings, press t he RESET butt on for t en seconds or
unt il t he POW ER LED begins t o blink and t hen release it . When the POW ER LED begins t o blink,
the defaults have been restored and the device restart s.
1.7 Wireless Access
The Device is a wireless Access Point (AP) for wireless client s, such as notebook com puters or PDAs
and iPads. I t allows them to connect to the I nt ernet without having t o rely on inconvenient Et hernet
cables.
I NTERNET Green On The Device has an I P connection but no t raffic.
Your device has a WAN I P address ( either st atic or assigned by a DHCP
server) , PPP negotiation was successfully completed ( if used) and t he
DSL connect ion is up.
Blinking The Device is sending or receiving I P traffic.
Off There is no I nternet connection or t he gat eway is in bridged m ode.
Red On The Device att em pt ed to m ake an I P connect ion but failed. Possible
causes are no response from a DHCP ser ver, no PPPoE response, PPPoE
aut hentication failed.
USB Green On The Device recognizes a USB connection.
Blinking The Device is sending/ receiving dat a t o / from the USB device connect ed
to it .
Off The Device does not det ect a USB connection.
Table 1 LED Descript ions (cont inued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
