ZyXEL Communications VMG1312-B Series - 10.6 The QoS Policer Setup Screen

Chapter 10 Quality of Service (QoS)
VMG1312-B Series User’s Guide
177
10.6 The QoS Policer Setup Screen
Use t his screen to configur e QoS policers that allow you t o lim it t he t ransm ission rate of incom ing
traffic. Click N et w or k Sett in g > QoS > Policer Se t up. The screen appears as shown.
Figure 69 Net work Sett ing > QoS > Policer Setup
The following t able describes t he labels in t his screen.
To Queue I ndex Select a queue that applies t o t his class.
You should have configured a queue in t he Que u e Se t up screen already.
Apply Click Apply t o save your changes.
Cancel Click Cancel t o exit this screen wit hout saving.
Table 45 Class Set up: Add/ Edit ( cont inued)
LABEL DESCRIPTION
Table 46 Net work Sett ing > QoS > Policer Setup
LABEL DESCRIPTION
Add new Policer Click this t o create a new entry.
# This is the index num ber of the ent r y.
St atus This field display s whether t he policer is active or not. A yellow bulb signifies t hat t his
policer is active. A gray bulb signifies that this policer is not active.
Nam e This field displays the descript ive nam e of t his policer.
Regulated
Classes
This field displays t he nam e of a QoS classifier
Meter Type This field displays t he t ype of QoS m et ering algorithm used in t his policer.
Rule These are t he rat es and burst sizes against which t he policer checks the traffic of the
m em ber QoS classes.
Act ion This shows t he how t he policer has t he Dev ice treat different t ypes of traffic belonging t o
the policer ’s m em ber QoS classes.
Modify Click t he Edit icon to edit t he policer.
Click the Delete icon t o delet e an exist ing policer. Not e t hat subsequent rules m ove up by
one when you take this act ion.