ZyXEL Communications VMG1312-B Series - Page 318

Appendix A Setting up Your Computer’s IP Address
VMG1312-B Series User’s Guide
318
2 I f you know your DNS server I P address( es) , enter the DNS server inform at ion in t he resolv.conf
file in t he /etc direct ory. The following figure show s an exam ple w here t wo DNS server I P
addresses are specified.
Figure 178 Red Hat 9.0: DNS Set t ings in resolv.conf
3 After you edit and save the configurat ion files, you m ust restart the network card. Enter ./network
restart in t he /etc/rc.d/init.d directory. The following figure shows an exam ple.
Figure 179 Red Hat 9.0: Rest art Et hernet Card
Verifying Settings
Enter ifconfig in a term inal screen t o check your TCP/ I P propert ies.
Figure 180 Red Hat 9.0: Checking TCP/ I P Properties
nameserver 172.23.5.1
nameserver 172.23.5.2
[root@localhost init.d]# network restart
Shutting down interface eth0: [OK]
Shutting down loopback interface: [OK]
Setting network parameters: [OK]
Bringing up loopback interface: [OK]
Bringing up interface eth0: [OK]
[root@localhost]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:50:BA:72:5B:44
inet addr:172.23.19.129 Bcast:172.23.19.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:717 errors:0 dropped:0 overruns:0 frame:0
TX packets:13 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:730412 (713.2 Kb) TX bytes:1570 (1.5 Kb)
Interrupt:10 Base address:0x1000
[root@localhost]#