1010music Bitbox Micro 1.0.7 User Manual

Page 19 of 88
Copyright 1010music LLC 2020
Bitbox Micro User Manual 1.0.7
Icon Pad Mode Description
Reverse
Playback
Beat
Sync
Set
Loop
Points
Play
Slices
Poly-
phony
Slicer Use with a WAV le with
dierent sections that
you want to trigger
independently.
√
2 notes
Granular Generate new sounds
from your samples. The
sample is played back in
small portions about 10
to 200ms in length,
called grains.
√ √
mono
New Rec Use to start recording a
new WAV le or clear a
WAV from a pad.
New Multi Automate recording of
multiple samples across
a range of notes
triggered via MIDI.
Each pad can have a dierent Pad Mode. You can use the same WAV le in dierent
pads in dierent Pad Modes. To load a WAV le into a pad:
1. Push the HOME button to bring up the Pads screen.
2. Select a pad by touching it or using the control knobs to cycle through the
pads. (The top control knob moves the selection horizontally. The bottom
control knob moves the selection vertically.) The selected pad is highlighted
pink. Touching a pad that is loaded with a WAV le will also trigger playback of
the pad.
3. Push the white right arrow button ► above the screen. If the pad was empty,
the WAV Load and Record screen will be displayed. If the pad already had a
WAV le assigned, the Waveform screen will be displayed.
WAV Load and Record
Screen
Waveform Screen WAV File Selection
Screen

1010music Bitbox Micro 1.0.7 Specifications

General

Brand	1010music
Model	Bitbox Micro 1.0.7
Category	Control Unit
Language	English