1010music Bitbox Micro 1.0.7 User Manual

Page 52 of 88
Copyright 1010music LLC 2020
Bitbox Micro User Manual 1.0.7
Parameter Description Supported
Pad Modes
Root Note
When you use the Keys screen or MIDI Notes to play this sample, the
base sample will play for this root note. The sample will be pitch shifted
up or down one semi-tone for each note away from the root note. Bitbox
micro will read the root note from the WAV le if available when you add
the WAV to the preset. However, you can specify a dierent value here
to be used for this WAV on this pad in this preset.
If you save the WAV le from this pad, the Root Note value will be saved
with it.
Stored in the WAV smpl tag.
Sample
(Single and
Multi),
Granular
LpStr
Point where the looping will begin when playing forward, or looping will
end when playing in reverse. Expressed in samples. Must be before or
equal to LpEnd.
LpStr is read from the WAV le when sample is loaded, and saved to
the WAV le when the WAV is saved.
Stored in the WAV smpl tag.
Sample
(Single)
LpEnd
Point where the looping will end when playing forwards, or looping will
begin when playing in reverse. Expressed in samples. Must be after or
equal to LpStr.
LpEnd is read form the WAV le when a sample is loaded, and saved to
the WAV le when the WAV is saved.
Stored in the WAV smpl tag.
Sample
(Single)
BeatCount
Enter the number of beats in the clip le to give bitbox micro more
information to work with when synchronizing playback to the current
song BPM.
Stored in the WAV acid tag.
Clip
Slice Points
The slice markers that are inserted into the le. Some other software
calls these Cue Points.
Stored in the WAV cue points.
Slicer, Clip
Save and Load Parameters in WAV Files
There are several pad parameters that bitbox micro can read from and write to WAV
les. There parameters are:

1010music Bitbox Micro 1.0.7 Specifications

General

Brand	1010music
Model	Bitbox Micro 1.0.7
Category	Control Unit
Language	English