To Next Page

To Previous Page

Page 51 of 88

Bitbox Micro User Manual 1.0.7

Note:

► If you delete, move or rename a WAV le, it will no longer be available for use by

presets that were previously using it. The name of the WAV le will still appear in

the Preset, but the Waveform screen will be blank until you load a new WAV le

into the pad.

► To remove a WAV le from a pad without deleting the le, go to the Waveform

screen and touch the Pad Mode icon to the left of the le name, and then touch

New Recording. You can press PADS to go back to the Pads screen without

loading a le and the pad will be empty.

► Bitbox micro supports samples in the WAV le format. It supports 1 or 2 channel

les with 16, 24 or 32 bit resolution at any sample rate. 48kHz is the preferred

sample rate.

► WAV le names may use Alpha Numeric Characters (A-Z, 0-9) and some special

characters. The following characters are NOT allowed:

“ / \ ? * < > : |

File names must be less than 256 characters, including the path name. Files that

do not conform to these naming constraints will not be recognized by bitbox

micro.

1010music Bitbox Micro 1.0.7 User Manual

Questions and Answers: