To Next Page

To Previous Page

Eect Parameter Settings Mod Target?

Delay

Delay Determines the delay length. When Beat Sync is

On, delay is specied in musical intervals:

1/64, 1/32, 1/16, 1/8T, 1/16D, 1/8, 1/4T, 1/8D, 1/4,

1/2T, 1/2, 1 bar

When Beat Sync is O, delay is specied as a

percentage from 0% to 100%.

Yes

Feedback 0 to 100%. Determines the amount of regeneration

or echo in the delayed signal.

Yes

Beat Sync This parameter controls whether the delay is

measured in musical time intervals or percentage.

Reverb

Decay 0 to 100%. How long the reverberation will ring out. Yes

Damping 0 to 100%. The amount of damping that is applied

to the reverb. Higher values will make the reverb

end sooner.

Yes

Predelay 0 to 100%. Determines the amount of delay in the

signal before the reverberation is applied. In real

life, this is related to how close the sources is to the

walls.

Note:

► The same eect parameter values are applied to all pads that are sending

signals to that eect.

► The Reverb eect is very processor intensive. Bitbox micro does not limit what

you can do based on anticipated processor needs. As a result, it is possible to

overdrive the processor, causing crackling and drop outs. See Processor

Management Tips below for more information about preventing sound artifacts.

Page 60 of 88

Bitbox Micro User Manual 1.0.7

1010music Bitbox Micro 1.0.7 User Manual

Questions and Answers: