3D Systems ZPrinter 350 - Zprinter 350;450 Components; System Exterior

ZPrinter
®
350 / ZPrinter
®
450 User Manual ZPrinter 350 and ZPrinter 450 Overview
3dscentral.3dsystems.com 7 All Rights Reserved
10/31/12
1.6 ZPrinter 350/450 Components
The main components of the ZPrinter 350 and ZPrinter 450 systems are highlighted below. Unless speci-
fied other wise, all components are the same on the two printers.
This manual applies to all ZPrinter 350 and ZPrinter 450 systems. Older units are called “Type 1” or “Type
2” and the newest versions are called “Type 3”. The Types are nearly identical, and any differences are
called out in the pictures that follow. Type 3 printers have “Type 3” printed on their serial number plates.
1.6.1 System Exterior
Number Component
1 Build Chamber
2 Fine Powder Removal Chamber
3 Arm Holes
4 Control Panel
5 LCD Display
6 Control Knob