3D Systems ZPrinter 350 - Additional Information; Materials; Service

To Next Page

To Previous Page

ZPrinter

350 / ZPrinter

450 User Manual Troubleshooting the ZPrinter 350/450

10/31/12

7.12Additional Information

7.12.1 Materials

Visit the Materials section of our Web site to get the latest information on:

• Materials that are compatible with your printer.

• Best Practices to help you create the very best parts.

3dscentral.3dsystems.com

7.12.2 Service

Visit the Support section of our Web site for tips on maintaining your printer, troubleshooting problems, or

to contact our Service staff:

3dscentral.3dsystems.com

Error 1905 Explanation: This error is caused by a layer that is too large for

the printer’s buffer. The printer is unable to process the layer and

reports the error. This is most common with GIS, architecture, and

scanned files, which are usually very large.

Solution: Try rotating the part on the X-Z-axis to increase the

layer count and reduce the size of each layer. The risk in doing this

is ZPrint is unable to check for layer size before it begins the build.

We recommend reducing the detail on the file and trying the print

again.

ERROR CODE