3D Systems ZPrinter 350 - Empty the Debris Separator

ZPrinter
®
350 / ZPrinter
®
450 User Manual Routine Cleaning
3dscentral.3dsystems.com 31 All Rights Reserved
10/31/12
you continue to vacuum powder into the feeder, the LCD will display
FEEDER POWDER LIMIT
and the vacuum will be disabled.
7. When you are finished, return the hose to its holder.
Important: Never vacuum up water or other fluids - it will clog the vacuum system.
3.2 Empty The Debris Separator
After vacuuming, empty the Debris Separator. The Debris Separator catches any large particles and keeps
those pieces from being recycled into the feeder. To empty the Debris Separator follow the steps below.
1. Pull the Debris Separator out of its holder on the printer.
2. Empty the contents into a trash receptacle.
3. Use the soft brush found in the Accessory Kit to brush any caked-on powder from the screen.
4. Return the empty Debris Separator to its holder. Be sure to push the Separator flat against the panel
for a secure fit.