Technical Information DFS 700 / 04.2009 2-4
(7) If work is required on disconnected parts, take a second person along who can trigger a
power-down in an emergency.
(8) Use only insulated tools!
Power Supply Unit Box (if available)
(1) As a basic principle the Power Supply Unit box is provided for use on the DFS 700 (on
the frame or in the Battery- & Mounting Box), but can also be used separately
considering the vertical alignment when placed indoors (workshop, office) or outdoors
(next to mounting location).
(2) Do not open/disassemble the Power Supply Unit box. Completely replace damaged or
non-functioning Power Supply Unit boxes, including the two cables. This also applies to
cable damage.
Battery (if available)
(1) Do not remove the Battery pole caps. A short circuit, which can destroy the Battery, is
created by bridging the positive and negative poles with metal. There is a risk of injury as
a result of parts heating up or arcing voltages.
(2) The Battery cable and poles should be undamaged; otherwise the Battery is to be
replaced.
(3) As a basic principle charge the Battery used in the Battery- & Mounting Box using the
Charger.
(4) Only charge and discharge removed Batteries in ventilated areas, as charging causes
poisonous and flammable gases to develop. No Smoking! Keep children away!
(5) Do not cover the Battery and do not place on radiators, heaters or open fires. Avoid
contact with water.
The optional Battery- & Mounting Box is the best location for the Battery while
charging and in use.
NOTE
To Next Page
Loading...
Need help?
General
