4IPNET EAP210 - Page 92

User’s Manual
Enterprise Access Point ENGLISH
Copyright © 4IPNET, INC. All rights reserved.
91
to reduce congestion in the 2.4GHz band. This is applicable only when the AP is set to 2.4GHz and
5GHz on the 2 RF Cards. When “Aggressive” is checked, clients with 5GHz connectivity are forced to
connect to the 5GHz band. Note that this is a general setting for the Access Point, and is not set per
RF Card.
 Interference Detection: When Utilization, Latency (and Invalid Packet Rate) of the current channel or
adjacent channel reaches the configured threshold (in %), the AP switches to a different Channel.
 WME Configuration: Access priority can be configured using with different parameters. CW Min:
Contention Window Minimum, CW Max: Contention Window Maximum, AIFS: Arbitration Inter Frame
Spacing, TXOP Limit: Transmission Opportunity Limit.
 Transmission Rate Threshold: The client will be kicked when transmission rate is lower than the
configured threshold. This ensures high connection speed for all associated clients.
 Note:
Features such as Short Preamble, Fragment Threshold, ACK Timeout, and Interference
Detection may be limited on RF Card B for selected AP models.