102 BM series
20.2. Options and Peripheral Equipment
Ethernet Interface BM-08
The interface to connect the balance to a LAN.
Accessory: "WinCT-Plus" data communication software.
The software can acquire data from
multiple balances connected to a LAN.
The software can control these balances
with commands.
The software can acquire data transmitted
from balances.
Example: When pressing the PRINT key
of the balance, data is output and is
acquired by the computer.
The stored data can be used with
Microsoft EXCEL (if installed).
Pipette Accuracy Tester BM-014
This option can be used to inspect the volume
dispensed from the pipette.
The accessory evaporation trap is used to
prevent the evaporation of the test liquid
inside it.
The WinCT-Pipette software converts the test
liquid mass into a volumetric value.
Electrode Unit of the Ionizer AX-BM-NEEDLESET (4 pieces)
Use these electrode units for replacement parts of the
ionizer built into the balance.
Replace all four units with new ones at the same time.
Refer to "6.5. Ionizer " for the replacement.
Display Cover AX-BM-031 (5 pieces)
This option is the same as the accessory display cover.
Micro Tube Holder AX-BM-032 (for the BM-20/22, standard accessory)
AX-BM-034 (for the BM-252/500/300/200)
This option is used when weighing with the general
micro tube or
test tube
under Φ
12 mm.
To Next Page
Loading...
