A&D BM-252 - Balance Software Version 1.660 or Later

76 BM series
15.2. Balance Software Version 1.660 or later
Three settings are available in “Password function (LocFnc) ” of the function table.
pA55 0 No password function.
pA55 1 Entering a password is required before starting weighing.
pA55 2 Logging in by the administrator password is required before making changes.
pA55 0 (No password function)
No password is required. Anybody can perform weighing, use all the balance functions and make
changes to them.
pA55 1 (Entering a password is required before starting weighing.)
The administrator (ADMIN ) sets unique passwords to restrict balance users. Pressing the
ON:OFF key before weighing will prompt you to enter a password.
The correct password must be entered for the balance to enter the weighing mode.
Two login levels are available: administrator (ADMIN ) and user (U5ER 01 to 10).
All the functions and settings can be used.
Administrator (ADMIN)
A password can be set for each of 10 users.
User (U5ER 01 to 10)
Initialization and changes to the settings are restricted,
including the clock setting.
No password The balance cannot be used.
pA55 2 (Logging in by the administrator password is required before making changes.)
Anybody can perform weighing, but initialization and changes to the settings are restricted,
including the clock setting. Even if the ON:OFF key is pressed to start weighing, a password
will not be required.
Two login levels are available: administrator (ADMIN ) and guest (GUE5t).
Administrator (ADMIN)
All the functions and settings can be used.
Guest (GUE5t)
*No password
Initialization and changes to the settings are restricted,
including the clock setting.
When weighing is started by pressing the ON:OFF key while holding down the CAL key in
the standby mode, the balance will prompt you to enter the administrator password.
Items restricted depending on the login level
Weighing
Login level
Entering password
before weighing
Calibration Changes to the settings *1
Administrator
(ADMIN)
Available Available
User
(U5ER 01 to 10)
Required
Guest
(GUE5t)
Not required
Available or
not available
*2
Not available
*1: Response adjustment, repeatability test, function switch and initialization, function settings
(clock setting)
*2: Available under ordinary circumstances, but not available to users and guests when the
administrator sets the function switch to “inhibit”.