A&D BM-252 - Selecting Units and Weighing Modes

22 BM series
5.3. Selecting Units and Weighing Modes
Preset the sequence of displaying units and
weighing modes to fit the frequency of use.
Refer to "5.2. Storing Active Units".
Press the MODE key in the weighing mode to
display the units and weighing modes in order.
For the BM-20 and BM-22, the units preset at
the factory, (Milligram) and (Gram), are
displayed in this order.
For the BM-252, BM-500, BM-300 and BM-
200, the units preset at the factory, (Gram)
and (Milligram), are displayed in this order.
Density mode
To use the density mode, it must be stored in
the function table as described on page 21.
Refer to "14. Density Measurement" for
details about the mode.
To select the density mode, press the
MODE key until the processing indictor
blinks with the unit "g" displayed.
The unit sequence of the factory settings.
Turning the display on.
BM-252
BM-500
BM-20 BM-300
BM-22 BM-200
Counting mode
P
ercent mode
Ounce (Avoir
)
Troy Ounce
Metric Cara
t
Momme
Pennyweigh
t
Grain (UK
)
Tael
Tola (India
)
Messghal
Density mode