IP PHONE FOR MX-ONE™
33 6/1553-DBC 444 01 Uen B4 2014-03-26
5.1.2 Logging On To the System
When the phone is logged on to the network, you can either use the
phone directly, or you need to log on to the telephony system, see below.
• The phone logs on automatically to the telephony system, and the
phone is ready to use. You cannot log on or log off. This mode can
be used for phones in, for example, receptions.
• The phone has to be logged on manually to the telephony system
before you can use it. You are either required to enter the extension
number, or the extension number and a password (or PIN code).
Note: The PIN code can be changed by the user (see 18.8.1
Changing PIN Code on page 114), whereas the password has to
be set by the system administrator.
The phone does not work during power failure. After a power failure the
phone automatically restarts. When the phone is starting up (rebooting),
any PC that is connected to the phone will loose its network connection
for about 10 seconds.
5.1.3 Free User
When log off is allowed, the phone must be logged on (registered) to the
telephony system before you can use it. When the phone is logged off,
the display will look like in figure 14 on page 33. If the emergency call
function is enabled, it is possible to make emergency calls. For more
information on emergency calls, see 8.3 Emergency Calls (SOS Calls)
on page 54.
Figure 14:Logon screen when log off is allowed
The last extension number used (by the previous user) remains until
changed.
To log on with your own extension number, do the following:
To Next Page
Loading...
