IP PHONE FOR MX-ONE™
39 6/1553-DBC 444 01 Uen B4 2014-03-26
6 Handsfree and Headset
This chapter describes how to answer and make calls in handsfree
mode or by using a headset.
The standard mode of answering and making calls is to lift the handset,
and this is also the default mode in the procedures described in this user
guide. However, it is often more convenient to use handsfree mode, or
a headset when handling calls. See below for detailed descriptions of
both options.
6.1 Handsfree Mode
In handsfree mode you do not lift the handset to start a procedure. And
to end a call, you press instead of replacing the handset.
By default, the phone is set to connect calls to the loudspeaker when you
answer incoming calls, or when you make calls by pressing a line key.
This default setting is known as the loudspeaker preset mode. When you
dial a number without lifting the handset, the call is also connected to the
loudspeaker by default.
Action Procedure
Answer a call Press the line button that indicates an
incoming call (the button's indicator is
flashing) or press Answer.
Make a call Dial the number you want to call. When
someone answers, the speakerphone
is activated. Then you can pick up the
handset, or continue to use the
speakerphone.
Clear a call
Press .
Switch from handsfree to
handset
Lift the handset.
Switch from handsfree to
headset
Press .
Switch from handset to
handsfree
Press and replace the handset.
To Next Page
Loading...
