3.6 Cleaning activities
3.6.1 Cleaning the IRB 6790
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
to the robot, before entering the safeguarded space.
General
To secure high uptime it is important that the IRB 6790 is cleaned regularly. The
frequency of cleaning depends on the environment in which the product works.
Oil spills
Oil spills from gearboxes
Use the following procedure if any oil spills are detected that can be suspected to
originate from a gearbox.
1 Inspect that the oil level in the suspected gearbox is according to the
recommendations, see Inspection activities on page 100.
2 Write down the oil level.
3 Inspect the oil level again after, for example, 6 months.
4 If the oil level is decreased then replace the gearbox.
Special cleaning considerations
This section specifies some special considerations when cleaning the robot.
• Always use cleaning equipment as specified. Any other cleaning equipment
may shorten the life of the robot.
• Always check that all protective covers are fitted to the robot before cleaning.
• Never point the water jet at connectors, joints, sealings, or gaskets.
• Do not use compressed air to clean the robot.
• Never use solvents that are not approved by ABB to clean the robot.
• Do not spray from a distance closer than 0.4 m.
• Do not remove any covers or other protective devices before cleaning the
robot.
Continues on next page
Product manual - IRB 6790 161
3HAC063331-001 Revision: B
© Copyright 2019 - 2020 ABB. All rights reserved.
3 Maintenance
3.6.1 Cleaning the IRB 6790
To Next Page
Loading...
