2.5 On-site storage
2.5.1 Increase the lifetime of the robot
During storage
There are ways to increase the lifetime of the robot during storage after test
installation (for example Factory acceptance test) and normal storage.
• Neutralize all detergents after tests or production. Lower the concentration
of detergents as much as possible to reduce wear of, for example, the seals.
• Use the air purge during storage. This will keep the over-pressure in the
system and reduce risks of detergents coming into motors and gears.
• The cell must be ventilated during shut-down until the atmospheric humidity
in the cell has reached the same level as the surrounding environment.
88 Product manual - IRB 6790
3HAC063331-001 Revision: B
© Copyright 2019 - 2020 ABB. All rights reserved.
2 Installation and commissioning
2.5.1 Increase the lifetime of the robot
To Next Page
Loading...
