7.2 Applicable standards
Note
The listed standards are valid at the time of the release of this document. Phased
out or replaced standards are removed from the list when needed.
General
The product is designed in accordance with EN ISO 10218-1, Robots for industrial
environments - Safety requirements -Part 1 Robot. If there are deviations, these
are listed in the declaration of incorporation which is included on delivery.
Standards, EN ISO
The product is designed in accordance with selected parts of:
DescriptionStandard
Safety of machinery - General principles for design - Risk as-
sessment and risk reduction
EN ISO 12100:2010
Safety of machinery, safety related parts of control systems -
Part 1: General principles for design
EN ISO 13849-1:2015
Safety of machinery - Emergency stop - Principles for designEN ISO 13850:2015
Robots and robotic devices -- Coordinate systems and motion
nomenclatures
ISO 9787:2013
Manipulating industrial robots, performance criteria, and related
test methods
ISO 9283:1998
Ergonomics of the thermal environment - Part 1EN ISO 13732-1:2008
EMC, Generic emissionEN 61000-6-4:2007 +
A1:2011
IEC 61000-6-4:2006 +
A1:2010
(option 129-1)
EMC, Generic immunityEN 61000-6-2:2005
IEC 61000-6-2:2005
Safety of machinery - Electrical equipment of machines - Part
1 General requirements
EN IEC 60204-1:2016
Degrees of protection provided by enclosures (IP code)IEC 60529:1989 + A2:2013
European standards
The product is designed in accordance with selected parts of:
DescriptionStandard
Safety of machinery - Ergonomic design principles - Part 1:
Terminology and general principles
EN 614-1:2006 + A1:2009
Safety of machinery - Two-hand control devices - Functional
aspects - Principles for design
EN 574:1996 + A1:2008
646 Product manual - IRB 6790
3HAC063331-001 Revision: B
© Copyright 2019 - 2020 ABB. All rights reserved.
7 Reference information
7.2 Applicable standards
To Next Page
Loading...
