Configuration
IM/265D/V-EN-02 265Dx, 265VS 57
Pos: 19.21 /Übers chriften/1.1/1-s paltig/M - O/Menügesteuer te Programmierung des Druckmessumformers @ 2\mod_1150 101484046_310 1.doc @ 29545
8.6 Menu-controlled pressure transmitter programming
Pos: 19.22 /Konfi guration, Parametr ierung/Druck/Dr uckmessumformer/All gemein/Menügesteuert e Programmierung des Dr uckmessumformers @ 17\mod_12011 85787890_3101.doc @ 154202
Function Description
Start
Menu-controlled programming is started with the mode
button "M".
Next menu item
The next menu item is called up by pressing the "+"
button.
Previous menu item
Press the "-" button to return to the previous menu item.
Activate submenu items/selection
lists
Submenu items and selection lists are activated by
pressing the mode button "M".
Change a numerical value
A numerical value can only be changed by means of
the "+" and "-" buttons. Please note that the "+" button
changes the value (each time the button is pressed, the
value increases by 1), while the "-" button is used to go
to the position of the value to be changed.
Acknowledge changes
Changes are acknowledged by pressing the mode
button "M". Confirming this (by pressing "OK") writes
the value to the non-volatile memory.
Exit
Once setting is complete, the program can be exited via
the "EXIT" menu item (acknowledge with the mode
button "M").
The next section contains the full menu structure, which provides an overview of the selection
and programming options.
Important
The button unit must be available for this purpose. Operating the buttons using a magnetic
screwdriver is not permitted.
Pos: 19.23 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
To Next Page
Loading...
