External EMC filters
The table shows the external EMC filters and which EMC categories are met with the filters.
The drive with internal EMC filter meets the C2 category. It is in use as standard in all IEC
drive types. See also EMC compatibility and motor cable length and EMC compliance
(IEC/EN 61800-3:2004 + A2012) (page 117).
CategoryEMC filter type
IEC type
ACS480-04-…
C3C2C1Schaffner order codeABB type code
3-phase U
N
= 400 V
xxxFN 3268-16-44RFI-3202A7-4
xxxFN 3268-16-44RFI-3203A4-4
xxxFN 3268-16-44RFI-3204A1-4
xxxFN 3268-16-44RFI-3205A7-4
xxxFN 3268-16-44RFI-3207A3-4
xxxFN 3268-16-44RFI-3209A5-4
xxxFN 3268-16-44RFI-3212A7-4
xxxFN 3268-30-33RFI-32018A-4
xxxFN 3268-30-33RFI-33026A-4
xxxFN 3258-100-35RFI-34033A-4
xxxFN 3258-100-35RFI-34039A-4
xxxFN 3258-100-35RFI-34046A-4
xxxFN 3258-100-35RFI-34050A-4
CategoryEMC filter type
UL (NEC) type
ACS480-04-…
C3C2C1Schaffner order codeABB type code
3-phase U
N
= 480 V
xxxFN 3268-16-44RFI-3202A1-4
xxxFN 3268-16-44RFI-3203A0-4
xxxFN 3268-16-44RFI-3203A5-4
xxxFN 3268-16-44RFI-3204A8-4
xxxFN 3268-16-44RFI-3206A0-4
xxxFN 3268-16-44RFI-3207A6-4
xxxFN 3268-16-44RFI-32011A-4
xxxFN 3268-30-33RFI-32014A-4
xxxFN 3268-30-33RFI-33021A-4
xxxFN 3258-100-35RFI-34027A-4
xxxFN 3258-100-35RFI-34034A-4
xxxFN 3258-100-35RFI-34042A-4
If you use an external EMC filter, you must disconnect the internal EMC filter. Refer to the
electrical installation instructions.
Technical data 111