ABB ACS480 - Installing the Drive; To Install the Drive with Screws; To Install the Drive to a DIN Installation Rail

Installing the drive
￭ To install the drive with screws
1. Mark the surface for the mounting holes. Use the mounting templates for R3 and R4
frames. For other frames, see the dimension drawings.
2. Drill the holes for the mounting screws.
3. Insert anchors or plugs into the holes (if necessary) and install the screws.
M1
M2
4. Position the drive onto the mounting screws.
5. Tighten the mounting screws.
5
￭ To install the drive to a DIN installation rail
Use the installation rail type Top Hat, W x H = 35 x 7.5 mm (1.4 x 0.3 in).
1. Move the locking part to the left.
1
2
3
Mechanical installation 37
10