Technical data 121
Isolation areas
Reinforced insulation (IEC/EN 61800-5-1:2016)
Functional insulation (IEC/EN 61800-5-1:2016)
The terminals on the control board fulfill the Protective Extra Low Voltage
(PELV) requirements (EN 50178): There is reinforced insulation between the
user terminals which only accept ELV voltages and terminals that accept
higher voltages (relay outputs).
Note: There is functional insulation also between the individual relay outputs.
Note: There is reinforced insulation on the power unit.
Control panel type
+J400 ACS-AP-S Assistant control panel (standard)
+J425 ACS-AP-I Assistant control panel
+J429 ACS-AP-W Assistant control panel with bluetooth interface
+J404 ACS-BP-P Basic control panel
Efficiency（EU ecodesign）
Energy efficiency data of IEC 61800-9-2 can be calculated by ecodesign
energy efficiency calculation tool:
http://ecodesign.drivesmotors.abb.com/
The energy efficiency data do not support single-phase 230V drive and
single-phase input drive are not included in the EU ecodesign requirements
(Regulation EU 2019/1781).
Degree of protection
IP00. With option +B051: IP20
19…21
RO1
22…24
RO2
25…27
RO3
EFB
EIA/R5-485
connection
34…38
STO
40, 41
Ext. 24 V
Power unit
connection
10…12
24 V
GND
13…15
DI
16…18
DI
1…3
AI1
4…6
AI2
7…8
AO
SLOT 1
Fieldbus module
Panel port
SLOT 2
I/O extension
module
To Next Page
Loading...
