22 Introduction to the manual
Contents of the manual
This manual contains the instructions and information for the basic drive module
configuration. The chapters of the manual are briefly described below.
Safety instructions gives safety instructions for the installation, commissioning, operation
and maintenance of the drive module.
Introduction to the manual introduces the manual.
Operation principle and hardware description describes the drive module.
Guidelines for planning the cabinet installation guides in planning drive cabinets and
installing the drive module into a user-defined cabinet. The chapter gives cabinet layout
examples and free space requirements around the module for cooling.
Guidelines for planning the electrical installation instructs in the motor and cable selection,
protections and cable routing.
Installation instructions gives the basic installation instructions that are common for the
different installation procedures.
Installation example of drive module with IP20 shrouds (option +B051) describes the
installation process of a standard drive module in a Rittal 600 mm wide cabinet.
Installation checklist contains lists for checking the mechanical and electrical installation of
the drive.
Start-up refers to the start-up instructions of the cabinet-installed drive.
Fault tracing describes the LED indications and refers to the fault tracing instructions of the
drive.
Maintenance contains maintenance instructions.
Technical data contains the technical specifications of the drive module, eg, the ratings,
sizes and technical requirements, provisions for fulfilling the requirements for CE and other
markings.
Dimension drawings contains dimension drawings of the drive module installed into a
Rittal TS 8 cabinet.
Example circuit diagram shows an example circuit diagram for a cabinet-installed drive
module.
Safe torque off function describes the Safe torque off function of the drive and gives
instructions on its implementing.
du/dt filters describes how to select du/dt filters for the drive.
Step-by-step drawings for an installation example of drive module with options +B051 and
+E208 in Rittal TS 8 600 mm wide cabinet shows how to install the drive module in a Rittal
TS 8 cabinet.
To Next Page
Loading...
