50 Guidelines for planning the cabinet installation
Planning the placement of the control panel
Note the following alternatives when you plan the placement of the control panel:
• As standard, the control panel is integrated on the control unit inside the drive module.
• The control panel can be mounted onto the cabinet door using a control panel
mounting platform (option +J410). For instructions, see DPMP-02/03 control panel
mounting platform kit installation guide (3AUA0000136205 [English]).
Planning the use of cubicle heaters
Use a cubicle heater if there is a risk of condensation in the cabinet. Although the primary
function of the heater is to keep the air dry, it may also be required for heating at low
temperatures.
Arc welding
Fastening the cabinet by arc welding is not allowed due to risk of electrical component
failure. However, if the arc welding is the only mounting option, remove the module from
the cabinet before welding.
To Next Page
Loading...
