Technical data 123
CE marking
A CE mark is attached to the drive to verify that the unit follows the provisions of the
European Low Voltage, EMC, and RoHS Directives. The CE marking also verifies that the
drive, in regard to its safety functions (such as Safe torque off), conforms with the
Machinery Directive as a safety component.
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according to
standards EN 60204-1 and EN 61800-5-1.
Materials
Drive enclosure • PC/ABS 2.5 mm, color NCS 1502-Y (RAL 9002 / PMS 420 C)
• hot-dip zinc coated steel sheet 1.5 to 2.5 mm, thickness of coating
100 micrometers, color NCS 1502-Y
Package Plywood and cardboard, bands PP.
Disposal The main parts of the drive can be recycled to preserve natural resources and
energy. Product parts and materials should be dismantled and separated.
Generally all metals, such as steel, aluminum, copper and its alloys, and
precious metals can be recycled as material. Plastics, rubber, cardboard and
other packaging material can be used in energy recovery. Printed circuit
boards and DC capacitors (C1-1 to C1-x) need selective treatment according
to IEC 62635 guidelines. To aid recycling, plastic parts are marked with an
appropriate identification code.
Contact your local ABB distributor for further information on environmental
aspects and recycling instructions for professional recyclers. End of life
treatment must follow international and local regulations.
Applicable standards
The drive complies with the following standards.
EN 61800-5-1:2016 Adjustable speed electrical power drive systems. Part 5-1: Safety
requirements – electrical, thermal and energy
EN 60204-1:2006 + A1:2010 Safety of machinery. Electrical equipment of machines. Part 1: General
requirements. Provisions for compliance: The final assembler of the machine
is responsible for installing
- emergency-stop device
- supply disconnecting device
- IP00 drive module into a cabinet.
IEC/EN 60529:1991 +
A2:2013
Degrees of protection provided by enclosures (IP code)
EN 61800-3:2004 +A1:2012 Adjustable speed electrical power drive systems. Part 3: EMC requirements
and specific test methods
UL 508C 3rd edition UL Standard for Safety, Power Conversion Equipment, second edition
To Next Page
Loading...
