24 Introduction to the manual
Standard drive modules
• Install the additional components into the cabinet: for
example, main disconnector, main contactor, main AC
fuses, etc.
• Install the drive module into the cabinet.
• Connect the motor cables to the drive module terminals.
• Connect the DC connection cables (if any) to the drive
module terminals.
• If the main disconnector is installed into the cabinet,
connect it to the drive module terminals and the input
power cabling to the disconnector.
Installing the drive module into a cabinet (page
93)
Connecting the power cables (page 79)
Manuals for any optional equipment
Drive modules with IP20 shrouds (option +B051)
Step-by-step drawings for an installation
example of drive module with options +B051
and +E208 in Rittal TS 8 600 mm wide cabinet
(page 175)
Connect the external control cables to the drive control unit. Connecting the control cables (page 82)
Check the installation. Installation checklist (page 97)
Commission the drive. Start-up (page 101)
Operate the drive: start, stop, speed control etc. Firmware manual
Task See
To Next Page
Loading...
