ABB i-bus KNX AC/S 1.x.1 Series - Page 266

ABB i-bus
®
KNX
Parameters
266 2CDC508198D0211 Rev. A | AC/S 1.x.1
Object name
Data type
Pump A fault DPT 1.005
The module has this output socket if the
Yes
option is selected for the
Pump display pump fault status
parameter.
Outputs the fault status provided by the pump.
Signal value:
0 = No alarm
1 = Alarm
Pump A repair switch status
DPT 1.011
The module has this output socket if the
Yes
option is selected for the
Display pump repair switch status
parameter.
Outputs the contact position provided by the pump repair switch.
Signal value:
0 = Inactive
1 = Active
Pump A override disable/enable
DPT 1.003
The module has this output socket if the Yes option is selected for the Override by WebUI parameter.
Outputs whether the heating distribution circuit's pump is overridden.
Signal value:
0 = Disabled
1 = Enabled
Pump A override value
DPT 1.001
The module has this output socket if the Yes option is selected for the Override by WebUI parameter.
Outputs the state with which the heating distribution circuit's pump is overridden if the pump override is active.
Signal value: 0 = Off
1 = On