ABB i-bus KNX AC/S 1.x.1 Series User Manual

ABB i-bus
®
KNX
Parameters
284 2CDC508198D0211 Rev. A | AC/S 1.x.1
Object name
Object type
Unit
COV send
condition
Heating distribution circuit: Pump B fault
Binary value
-
-
The module has this BACnet output object if the Yes option is selected for the Double pump parameter and the Yes option is
selected for the Pump display pump fault status parameter.
Outputs the fault status provided by the second pump.
Signal value: 0 = Inactive
1 = Active
Heating distribution circuit: Pump B repair switch status Binary value - -
The module has this BACnet output object if the Yes option is selected for the Double pump parameter and the Yes option is
selected for the Display pump repair switch status parameter.
Outputs the contact position provided by the second pump repair switch.
Signal value:
0 = Inactive
1 = Active
Heating distribution circuit: Valve control value
Analog value
% (98)
1.0
The module has this BACnet output object if the 3-way valve (mixing valve) option or the 2-way valve option is selected for the
Valve type
parameter.
Outputs the valve control value for the heating distribution circuit. This value is received from the heating distribution circuit
controller linked via the related module group object.
Signal value:
0…100%
Heating distribution circuit: Valve override disable/enable
Binary value
-
-
The module has this BACnet output object if the
3-way valve (mixing valve)
option or the
2-way valve
option is selected for the
Valve type parameter and the Yes option is selected for the Valve override disable/enable parameter.
Outputs whether the override of the heating distribution circuit's valve is active or inactive.
Signal value:
0 = Disabled
1 = Enabled

ABB i-bus KNX AC/S 1.x.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX AC/S 1.x.1 Series
Category	Controller
Language	English