2 Installation and commissioning
2.5.11. Installation of cooling fan for motors, axes 1-3 (option)
993HAC023082-001 Revision: E
© Copyright 2004-2008 ABB. All rights reserved.
Plate for customer connections, at base
xx0500002301
Plate for customer
connections
3HAC025778-001 An additional connection plate must be
fitted to the robot base, if not already
installed. The plate is shown in the figure
Plate for customer connections, at base
on page 99.
Additional cabling to and
inside the controller
- Specified in section Position switch and
fan cables, robot base to controller
(option) on page 123.
Locking liquid - Loctite. Used for the three tightening
screws.
Standard toolkit - The contents are defined in section
Standard toolkit on page 436, in part 2 of
the Product manual.
Circuit diagram - See chapter Circuit diagram in the
Product manual, reference information.
Other tools and procedures
may be required. See
references to these
procedures in the step-by-
step instructions below.
These procedures include references to
the tools required.
Equipment Art. no. Note
A Plate for customer connections
B Attachment screws, 3 pcs, M6x16
Continued
Continues on next page
To Next Page
Loading...
