3 Maintenance
3.3.8. Inspection, cable harness
3HAC023082-001 Revision: E160
© Copyright 2004-2008 ABB. All rights reserved.
Location of cabling axes 5-6
The robot cable harness, axes 5-6, is located as shown in the figure below.
Note! The cable harness is also available without the division point R2.M5/6. Except for the
connectors at the division point, the rest of the inspection points are the same for the harness
that runs undivided from axis 1 to axis 6.
xx0200000234
A Connectors at cable harness division point, R2.M5/6
B Cable attachment, rear of upper arm
C Cable attachment, upper arm tube
Continued
Continues on next page
To Next Page
Loading...
