4 Repair
4.3.1. Replacement of cable harness, axes 1-6
3HAC023082-001 Revision: E236
© Copyright 2004-2008 ABB. All rights reserved.
9. Reconnect connectors R2.SMB, R1.SMB1-3,
R1.SMB4-6 to the SMB unit.
Reconnect X8, X9 and X10 to the brake
release unit.
Reconnect R1.G if it has been disconnected.
xx0200000118
10. Secure the SMB cover with its attachment
screws.
11.
WARNING!
Before continuing any service work, please
observe the safety information in section
WARNING - The brake release buttons may
be jammed after service work on page 39!
12. Pull the cable harness through the lower arm.
13. Refit the cable gland securing the cables
inside the lower arm.
xx0100000142
Action Note
Continued
Continues on next page
To Next Page
Loading...
