Note/IllustrationAction
Fit the cameras to the mounting rail (not
supplied from ABB).
2
Connect the Ethernet cable from the
camera to the Device port on the com-
puter and logic unit.
Tip
The MGMT port can be also used for
connecting the Ethernet cable for the
camera.
3
Connect the 24V power supply to the
cameras from the other power supply.
4
See Application manual - Integrated Vision.Connect wires to the inputs and output
connectors as required.
5
For more information about the option Integrated Vision, see Application
manual - Integrated Vision.
Product manual - OmniCore E10 103
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.6.1 Installing Integrated Vision
Continued
To Next Page
Loading...
