ABB OmniCore E10 - 3.5.5 Connecting power supply to and grounding the controller

3.5.5 Connecting power supply to and grounding the controller
Note
How to manufacture a cable with connector is described in section Fitting the
connector on page 72.
DANGER
A residual current device (RCD) must be installed.
Location of power supply connection
xx2100001301
Location of grounding point
A
B
C
xx2100001302
Description
Live (L1)A
Neutral (N) or Live (L2)B
Protective Earth (PE), groundingC
Continues on next page
Product manual - OmniCore E10 73
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.5.5 Connecting power supply to and grounding the controller