ABB OmniCore E10 - 3.6 Installing add-on devices

3.6 Installing add-on devices
3.6.1 Installing Integrated Vision
Required parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore E10 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
3HAC053944-0018 mm camera lens, LTC-08F
3HAC053944-00212.5 mm camera lens, LFC-12.5F
3HAC053944-00316 mm camera lens, LFC-16F1
3HAC053944-00425 mm camera lens, LFC-25F1
DSQC10203HAC053953-001Integr Vision camera med. Res
DSQC10213HAC053954-001Integr Vision camera high res
3HAC051753-003Integr Vision power cable
3HAC051736-003Integr Vision ethernet cable
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 202.
-Standard toolkit
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC076810-008Circuit diagram - OmniCore E10
3HAC067707-001Application manual - Integrated
Vision
Installing Integrated Vision camera connections
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
Continues on next page
102 Product manual - OmniCore E10
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.6.1 Installing Integrated Vision