ABB OmniCore E10 - Replacing the Fasten Strip

5.4.3 Replacing the fasten strip
Location
The illustration shows the location of the fasten strip on the FlexPendant.
xx1900000771
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore E10 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
3HAC065419-001Fasten strip
Replacing the fasten strip
Note/IllustrationAction
Open the velcro on the fasten strip.1
Take the fasten strip out from the holes.2
Insert the new fasten strip into the holes
one by one.
3
Secure the velcro in a suitable length.4
164 Product manual - OmniCore E10
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.4.3 Replacing the fasten strip