3.5.4 Fitting the connector
General
This section describes how to manufacture a cable for connecting the main power
to the controller.
DescriptionConnector article
number
Connector
IEC 60320 C19 connector3HAC077706-001Connector AC power
inlet
As this is a standard connector, it is sug-
gested to use the normal method to fit the
connector.
Specifications
The following describes the cable requirements for the main power connection to
the OmniCore E10 controller.
DescriptionComponent
Flexible oil resistant rubberCable type
3C x 1.5 mm
2
or AWG16Cable area
72 Product manual - OmniCore E10
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.5.4 Fitting the connector
To Next Page
Loading...
